Skip to content
For the complete documentation index, see llms.txt. This page is also available as Markdown.

Typical Network Connection

This section shows some typical network setup, although the AMAS system agnostic to the type of network with a Peer-to-Peer connection.

Our peripheral devices are shipped with static IP with the gateway range 192.168.0.xxx. This is normally labelled on the device. We use a custom communication protocol based on TCP/IP, UDP.

Assuming the network connectivity is provided by the user, the typical network architecture is as below:

Typical connection using an ordinary WIFI setting
Typical connection using 5G connectivity

Connectivity via Public Network

We recommend utilising the port forwarding functions of a commercial router to forward a designated static public IP address and ports to local IP addresses and ports.

Pre-requisite: you must obtain a Public Static IP Address from your network provider.

As an example:

The network will need to allow these ports to be used over the Internet to access the devices with below network settings:

  • RoboKit:

    • Local IP: 192.168.0.140,

    • ROS Port: 9090

  • SenseKit 1

    • Local IP: 192.168.0.141

    • ROS Port: 9091

    • Data Port:12345

  • SenseKit 2

    • Local IP: 192.168.0.142

    • ROS Port: 9092

    • Data Port:54321

You can use port forwarding on an ASUS Wi-Fi router. The port forwarding can be configured following: https://www.asus.com/support/faq/1037906/. In total, 5 port forwarding rules need to be setup as below:

Last updated

Was this helpful?