SenseKit Addition and Configuration

Guide to add a new SenseKit and configure it.

Adding a New SenseKit

Following are the steps required to add a new SenseKit:

1. Open the Configuration tab in the wrist panel.

2. Press on the SenseKits button, which will open the Active SenseKits panel.

Note: Since, there are currently no active devices, so it is empty.

1. Press on Add New button, which will open the panel with input fields.

2. Input the IP and port (default port is 9091) of the SenseKit.

3. Press Connect this will try to connect to the SenseKit device and find any configurations saved on the SenseKit device.

4. If any configuration are stored on the SenseKit device it will be shown in the panel, which could be selected to load the configuration available.

5. If no configurations are available click on Create New Config button on the panel.

6. To create a new config, you would need to provide the Name and Data Port (default is 12345) for the SenseKit connection in the panel.

7. Press Save Local or Save Local and Device to finish the configuration and connect to the SenseKit.

8. The Active SenseKits panel will now show this SenseKit.

Adding a New SenseKit

Modifying a Currently Active SenseKit

Follow the steps given below to modify a currently active SenseKit:

1. Open the Configuration tab in the wrist panel.

2. Press on the SenseKits button.

3. Press on the SenseKit you would like to modify.

4. Edit the configuration of the SenseKit accordingly.

5. Press Save. This will update the SenseKit, and will update the stored configuration